Quick Start Guide

ManualsBrandsCTA Digital ManualsComputersHeavy-Duty Security Gooseneck Floor Stand for 7 - 13" Tablets

Heavy-Duty Security Gooseneck Floor Stand

for 7-13 Inch Tablets

PAD-SHFS

1.Going the Cable Through the Cable Routings on the Pole

1.Put the top pole to the lowest position,insert the cable into the cable routing on the bottom pole and push inward.

2.Draw out the top pole and continue to push inward the cable until the cable head is visible through the cable routing on the top pole .

3.Draw out the cable head from the cable routing on the top pole .

This product allows you to go through the cable from the cable routings on the pole.

2.Stand Assembly:

3.Connecting the Gooseneck Tablet Holder & Battery Case

1. Insert the pole into the center of the heavy duty base.

2. Place metal washer over tightening screw rod, then screw into the

bottom side of the stand base center, turning clockwise to tighten.

Gooseneck

Metal

Connection

2.Place gooseneck over metal connection

then turn clockwise to screw down until tight.

METAL CONNECTION

HEAVY DUTY BASE

HEIGHT

ADJUSTMENT

KNOB

POLE

METAL WASHER &

TIGHTENING SCREW ROD

Attaching wheels:

Connect wheels to stand base before attaching pole.

Screw wheels into floor base by hand,

then use wrench to tighten.

Star Allen Key

3.Use the smaller Star Allen key to tighten the

small star meter screw inside the gooseneck.

Note: if meter screw is already in, unscrew

before attaching gooseneck in step 2.

Battery Case

1. Place battery case over metal

connection on the pole.

4. Installing your Device and Adjusting the Tablet Holder

1. Insert key into lock at back of holder.Turn counter-

clockwise to unlock, then slide to open.Insert tablet

against fixed end,then slide down to hold tight.

Turn key clockwise to tighten.

2. Use Allen key to adjust tension at point of

connection between the tablet holder and

gooseneck,flex the gooseneck to adjust the view

angle according to your needs.

Allen Key

360 rotation

270

rotation

Key

Multi

direction

flexing

3. Rotate plastic grip counter-clockwise

to loosen, then adjust pole to desired

height. Rotate plastic grip clockwise to

tighten.

Instructions:

Package Contents: