User Manual

1mm Foam Pad
5mm
Foam
Pad
for 7-14 Inch Tablets
PAD-PPM
3.Installing your Device:
Package Contents:
Portable Projector Stage and Photo Studio Mount
Select the appropriate foam pad according to the thickness of
your tablet or case. Press adhesive side into center of tablet
holder.
Use this table to determine the appropriate foam pad to use with your tablet.
Note: sizes refer to total tablet size with or without a case.
Foam Pad
Thickness
1mm
5mm
10mm
Tablet Thickness
0.51-0.91in / 13-23mm
0.31-0.71in / 8-18mm
0.67-1.06in / 17-27mm
2. Attaching Foam Pad to Tablet Holder
Press button on side of tablet holder to slide open. Insert your
tablet against spring arm. Slide other end back to secure device.
1.Use the Allen key to tighten and loosen
the connection between the arm and the holder,
adjusting ease of rotation in the tablet holder.
1.Connecting the Portable Projector Stage and Photo Studio Mount:
Instructions:
1.Align the pole and plate using the three holes.
Screw them together from the bottom up using
included screws.
2. Go through the ring of the Arm and Holder unit to the
pole. Place it at your preferred height then turn the
handle rod to tighten.
Note: if the handle rod of the ring is already in too much,
unscrew before going through to the pole.
10mm
Foam
Pad
4.Adjustment:
360 rotation
o
270 rotation
o
2. Rotate the handle rod of the ring counter-clockwise to loosen,
then adjust the arm and holder unit to desired height and direction.
Rotate the handle rod clockwise to tighten.
3. Rotate the arm freely to adjust your device to preferred position.