Tus neeg siv phau ntawv

FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution:
Changes or modifications not expressly approved by the part responsible for
compliance could void the user's authority to operate the equipment.
FCC RF Radiation Exposure Statement Caution:
This Transmitter must be installed to provide a separation distance of at least 5
mm from all persons.
FCC Statement:
"This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help."
MONO MODE
(SINGLE EARBUD USE)
— Remove earbud from charging
power on by pressing the control button (7)
or (5) for 3 seconds depending on which
earbud your using.
— Once earbud is powered on, proceed to PAIRING
case and
— Remove both earbuds from charging
case and place them in your ears.
— Make sure Bluetooth
®
Search Mode is turned
off on your mobile device.
— Hold the right earbud button (7) for 3
seconds and then press left earbud button
(5) for 3 seconds until they are powered on.
(Earbud LEDs will flash Red and Blue to
indicate that they are in Link mode.)
— Earbuds will automatically link together after
a few seconds,and earbuds will have a tone
(LEDs will flash blue)
— Once Earbuds are linked together you may
proceed to pairing with your mobile device.
STEREO MODE
(DUAL EARBUD USE)
PAIRING
*Note: Once earbuds have been initially paired successfully with
your mobile device they will automatically pair the next time
— Enable Bluetooth search mode on
your mobile device and search for
pairing name “PODZ TWS EARBUD
” and select it on your mobile
phone. Once the earbuds are
successfully paired a notification
will sound.
u — Now you can enjoy yo r true
wireless Bluetooth Earbuds.
PODZ TWS EARBUD
OPERATING BLUETOOTH EARBUDS
Function Operation
Power On Press (5) or (7) for 3 seconds
Power Off Press (5) or (7) for 5 seconds
Play/Pause Single press (5) or (7)
Answer
Reject
Earbuds LED indications (4) & (6)
Power On
Red and Blue LED will flash altemately
Link Mode Flashing Blue + Red
Paired Successfully Flashing Blue
Power Off LED Off
Earbuds in Case
Charging Light Red
Fully Charged
Light Off
Charging Case See CHARGING YOUR CASE
Single press (5) or (7)
Press (5) or (7) for 2 seconds
they are powered on.