User Manual

FCC Warning Statement
Changes or modifications not expressly approved by the party
responsible for compliance could
void the user’s authority to operate the equipment. This equipment
has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct
the interference by one
or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment
and receiver.
‐‐Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. ‐‐ Consult the
dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation. The device has been evaluated to meet
general RF exposure requirement.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.