Owners manual

22. Remove the sway bar bolts. ( 14mm socket )
23. Install the sway bar drop mounts using the stock bolts and locktite; orient them so it
pushes the sway bar forward (Threaded holes to the front ). ( 14mm socket )
24. Bolt the sway bar to the drop mounts using the supplied 3/8 bolts and locktite. (
9/16 socket )
25. Bolt the sway bar links to the spindles using the stock nuts and locktite. ( 17mm
socket )
26. Attach the tie rod end to the spindle using the stock nut. Install a new cotter pin. (
19mm socket )
27. Carefully bend the brake line around to line up with the new bracket that is welded into
the spindle. Attach it using the stock clip.
28. Attach the brake line drop bracket to the frame using the bolt that held the brake line to
the frame. Carefully bend the brake line down far enough to line up with the lower hole
in the bracket. Attach the line to the bracket using the supplied 5/16 bolt. (
12mm socket, ½” socket, ½” wrench )
29. Route the antilock wire down the brake line and attach it to the antilock sensor in the
spindle. Use zip ties to attach it to the brake line and the tab on the inside of the
spindle. ( pliers, dikes )
30. Install the rear lift ( Not Included ) according to the instructions provided with the rear
parts.
31. Install the wheels. ( 21mm socket )
32. Set the truck back on the ground and torque the lug nuts to 100 ft. lbs.
33. Torque the u-bolts to 85 ft. lbs.
34. Turn the tires all the way both ways and check the brake lines and the antilock wires to
make sure they are not going to rub on the wheels or get pinched in any suspension
components.
35. Set the toe approximately straight. Have the truck professionally aligned. (
22mm
wrench, 15mm wrench )
PARTS LIST:
4 3/8 X 3/4 BOLTS
4 3/8 WASHERS
8 ZIP TIES
2 COTTER PINS
2 BRAKE LINE BRACKETS
2 5/16 X 1 BOLTS
2 5/16 LOCKNUTS
2 5/16 WASHERS
1 DRIVERS SIDE SPINDLE
1 PASSENGER SIDE SPINDLE
1 PARTS BAG # 1
2 ALUMINUM SWAY BAR BRACKETS