Owners manual

14385 Veterans Way Moreno Valley, CA 92553

Phone: (951) 571-0212 Fax: (951) 571-0215

2006-2011 FJ CRUISER

2003-2011 4 RUNNER

2005-2011 TACOMA 4WD AND PRE-RUNNER

CSS-T2-3

BILLET ALUMINUM UPPER ARM KIT

READ THE FOLLOWING NOTES PRIOR TO INSTALLATION

DO NOT ALTER THE FINISH OF ANY COMPONENTS. CHANGING THE FINISH SUCH AS CHROMING, ZINC-

PLATING, OR ANY TYPE OF PAINTING, CAN CAUSE STRUCTURAL FATIGUE OF COMPONENTS.

PRIOR TO INSTALLATION, COMPARE THE PARTS LIST WITH THE COMPONENTS RECEIVED IN THE KIT. IF

ANY PIECES ARE MISSING PLEASE CONTACT YOUR LOCAL RETAILER OR CST PERFORMANCE

SUSPENSION AT 951-571-0212, AND YOU WILL BE TAKEN CARE OF IN A TIMELY MANOR.

READ ALL INSTRUCTION FROM START TO FINISH BEFORE BEGINNING

INSTALLATION. IF THESE INSTRUCTIONS ARE NOT PROPERLY FOLLOWED, SEVERE FRAME, TIRE, OR

SUSPENSION DAMAGE MAY RESULT TO THE VEHICLE. IF YOU INCUR A PROBLEM DURING THE

INSTALLATION OF THIS KIT, FIRST BE SURE YOU HAVE FOLLOWED THE INSTRUCTION FROM START

TO FINISH ACCURATELY AND IF SO PLEASE CALL 951-571-0212, WE WILL DO OUR BEST OVER THE

PHONE TO ASSIST YOU WITH YOUR PROBLEM, OR DIRECT YOU ACCORDINGLY.

VEHICLES THAT RECEIVE OVER SIZED TIRES SHOULD CHECK BALL JOINTS, TIE ROD ENDS AND PIVOT

POINTS, AS WELL AS GENERALLY INSPECT THE ENTIRE SUSPENSION FRONT TO REAR EVERY 2500 –

5000 MILES FOR WEAR AND REPLACE PARTS AS NEEDED.

PAGE 1
4385 Veterans Way Moreno Valley, CA 92553 Phone: (951) 571-0212 Fax: (951) 571-0215 2006-2011 FJ CRUISER 2003-2011 4 RUNNER 2005-2011 TACOMA 4WD AND PRE-RUNNER CSS-T2-3 BILLET ALUMINUM UPPER ARM KIT READ THE FOLLOWING NOTES PRIOR TO INSTALLATION DO NOT ALTER THE FINISH OF ANY COMPONENTS. CHANGING THE FINISH SUCH AS CHROMING, ZINCPLATING, OR ANY TYPE OF PAINTING, CAN CAUSE STRUCTURAL FATIGUE OF COMPONENTS. PRIOR TO INSTALLATION, COMPARE THE PARTS LIST WITH THE COMPONENTS RECEIVED IN THE KIT.
PAGE 2
INSTRUCTIONS: 1. Your new CST arms come fully assembled. You should not need to adjust the position of the heim joints. Any alignment adjustment should first be done with the adjusters on the lower arms. If the lower arms do not provide enough adjustment to get the truck aligned then you can adjust the upper. 2. Jack the truck up and support it with 4 jack stands under the frame. Never work under an unsupported vehicle. 3. Remove the wheels. ( 21mm Socket ) 4.