Specifications

Smart Machine Smart Decision
SIM900_AT Commands Manual_V1.07 203 2012.12.10
8.2.23AT+CIPCCFG Configure Transparent Transfer Mode
AT+CIPCCFG Configure Transparent Transfer Mode
Response
+CIPCCFG:
(NmRetry:3-8),(WaitTm:2-10),(SendSz:1-1460),(esc:0,1),(Rxmode:0,1),(
RxSize:50-1460),(Rxtimer:20-1000)
OK
Test Command
AT+CIPCCFG=
?
Parameters
See Write Command
Response
+CIPCCFG:
<NmRetry>,<WaitTm>,<SendSz>,<esc>,<Rxmode>,<RxSize>,<Rxtime
r>
OK
Read Command
AT+CIPCCFG?
Parameters
See Write Command
Response
OK
ERROR
Write Command
AT+CIPCCFG=
<NmRetry>,<Wa
itTm>,<SendSz>,
<esc>[,<Rxmode
>,<RxSize>,<Rxt
imer>]
Parameters
<NmRetry> Number of retries to be made for an IP packet.
<WaitTm> Number of 200ms intervals to wait for serial input before
sending the packet.
<SendSz> Size in bytes of data block to be received from serial port
before sending.
<esc> Whether turn on the escape sequence, default is TRUE.
0 Turn off the escape sequence
1 Turn on the escape sequence
<Rxmode> Whether to set time interval during output data from serial
port.
0 output data to serial port without interval
1 output data to serial port within <Rxtimer> interval.
<RxSize> Output data length for each time, default value is 1460.
<Rxtimer> Time interval (ms) to wait for serial port to output data
again. Default value: 50ms
Reference Note
This command will be effective only in single connection mode