User's Manual

User Manual
Dog Training Collar Model : CSW-M783
Congratulaons on buying this training collar, if for any
reasons you are not 100%sasfied with your training collar,
please contact our customer service immediately so that
we can help you.Please read the manual carefully before use.
1. Easy to operate, use + or - key to quickly adjust the
intensity of electric shock, vibraon and beep.
2. Four modes: electric shock, vibraon, beep and LED mode,
which can meet different training requirements.
3. This product can control one or two receiving collars.
4. Open area can be controlled within 300 meters.
5.Waterproof design.
6.Power-saving design,The receiver automacally enters
the power-saving state of sleep in the 3-minute stac state
and wakes up quickly when moving.
1. Remote control charging
Insert the charging cable Micro terminal into the remote control,
insert the other terminal into the charger, and then connect to
the power supply to start normal charging. The baery symbol
on the LCD screen starts to flash, and stops flashing aer full charge.
2. Receiver charging
Insert the charging line Micro terminal into the receiver, insert the
other terminal into the charger, and then connect to the mains to
start normal charging. Red LED lights on, full power red LED
lights off, green LED lights on.
Charging
Features
About 2-3 hours can be full of power
Please choose the matching charger, try to choose
the charger of 5V/0.5A-5V/1A, otherwise it is easy
to damage the product.
Remark:
1.First, put the newly purchased product into sufficient power,
then turn on the receiver (collar), press the power buon on the
receiver, you will hear a ck, and the green light will start to shine,
shining once in about 3 seconds. In the boot state, long press the
power switch on, green light for about 1 second 3 speed shiny,
shiny said in pairing mode, there are 10 seconds, to operate the
key of electric shock and vibraon on the remote control key,
beep key pairs for learning, according to the three funcon keys,
the red LED will light up on the remote control, loosen the
buon LED lights, transmit signal to go out to receive said.
Aer 10 seconds of pairing, the green light will stop flashing
quickly and turn to slow flash and enter standby mode.
2.Select two receivers for pairing. Aer compleng the first
pairing, switch the remote control [ ] buon once and press
it briefly to switch to another receiver mode.
If no match is successful, it may be caused by
external environmental factors, please operate
twice more. Again, please contact the nearest
distributor or customer service personnel.
The remote is paired with the receiver
Introduction of appearance
1: Electric shock key 2: Vibraon key 3: Beep 4: Lighng key
5: Switch 6: Lock key 7:Charging port 8/9: Intensity
adjustment key 10: Antenna 11: Highlighted LED floodlight
12:Launch indicator 13: Latch 14: Receiver on / off key / learning
key 15: charging port 16/ 17: shock contact 19: status indicator
The receiverThe remote control
Package List
1* Receiver (oponal *2) 1* Belt (oponal *2)
1* USB Charging Line 1* Charger
1* Remote Control 1* User Manual
1* Box