User guide

BB2-7040 User Guide – Rev. 1.2 Page 5
Once you have identified your PC’s IP address, use the route command to add a routing table entry. The syntax, using
the above IP address as the example, would be:
route add 10.0.0.0 mask 255.255.255.0 192.168.1.101
Note that the mask you use should also match whatever you found with ipconfig.
Once you have done the route command, you can simply do ‘route print’ to verify your routing table. The result of ‘route
print’ should look somewhat like the example that follows, although this will vary greatly from one network and PC to
another.