User guide

BB2-7040 User Guide – Rev. 1.2 Page 50
Appendix B Connecting Digi International Wireless Devices
The Digi devices mentioned here may be purchased from Digi International.
B.1 Configuring the Digi XBee Sensor
Send the following commands to the Digi Sensor, substituting your own PAN ID for the example shown.
/ID 00 00 00 00 00 00 02 34
/NI “---name---“
/SN 00 3B
/SP 01 F4
/D1 02
/D2 02
/D3 02
/IR FF FF
/ST 03 E8
/WR
The data parse masks will be as follows:
92----------------------------0E----XXXX-------- Light
92----------------------------0E--------XXXX---- Temperature
92----------------------------0E------------XXXX Humidity
B.2 Configuring the Digi XBee SmartPlug
Set the PAN ID and Network Identifier. The write map’s Data Format Mask will be as follows:
[17][F][A][N][02]D4[X]
This assumes the BACnet object mapped will have a value of 0 or 1, and further assumes an AND mask of 1 and an OR
mask of 4.
B.3 Configuring the Digi Wall Router
You will only need to set the PAN ID and sleep period in the router. Use the /SP command to set the sleep period to a
value at least as large as the longest period set in any sensor (or endpoint). The router never sleeps, but needs to know the
sleep period used by endpoints so that the router knows how long to wait for a reply from the endpoint.