User guide

BB2-7040 User Guide – Rev. 1.2 Page 31
To change the IP address of this device, enter the address, subnet mask, and gateway, then click "change IP". Set the
IP address to 255.255.255.255 to specify that DHCP should be used to obtain an IP address upon power-up. IP address
change will take effect upon next power cycle.
The default port for web page serving is 80. If you wish to change it, enter the port number and click Set Port. This
change will take effect upon the next power-up. If the port is anything other than 80, you must include the port number in
the URL. For example, if you would normally use http://10.0.0.101/ to get here and you change the port to 8215, you
would now use http://10.0.0.101:8215/. (Note: The port change is only accepted if you are logged in as the root user.)
8.4 User Accounts and Passwords
You are logged in as the root user if you see this page. You may enter user names, their passwords, set their privilege
levels, and enter an optional IP filter. If the IP filter is a non-zero valid IP address, the user may only log in from that
IP address.
Changes will take at least a full minute before this page will refresh.