User guide

BB2-7040 User Guide – Rev. 1.2 Page 28
8 System Setup
8.1 Configuration Files
IMPORTANT: Configuration changes will be lost the next time you cycle power if you did not click the "save" button to
place those changes in non-volatile memory (Flash file).
Click "Save" to store the present configuration to a Flash file. The configuration will overwrite the selected file in the
local file directory unless you check "create new file" and enter a new file name.
Click "Load" to load the currently selected file in the local file directory. This means reconfigure the system from this
file. Changes take effect immediately and could have consequences. Be certain to understand the changes you are
invoking before clicking "load".
Click "Boot" to select a different boot configuration file. This is the Flash file that is automatically loaded upon power-
up.
Click "View" to look at the selected file. It should be an XML file, and your browser will recognize it as such if properly
formatted.
Click "Delete" to remove a file from the local file directory.
Click "Browse" to select a file for upload from your PC. Once selected, then click "Upload" to complete the process.
Check "Confirm" and click "Restart" to re-boot the system. This will not cycle power to the hardware, but will reboot the
processor as if power had been cycled. Use this to force an IP address change remotely. Only the root user is allowed to
do this. Upon restart, this page will not reload and the HTTP connection will be lost.