User manual

PCI-7030 User Manual 20
.
2.15 ATX Feature connector(ATXF1)
The PCI-7030 can support an advanced soft power switch function, if an ATX power
supply is used. To enable the soft power switch function:
1. Get the specially designed ATX-to-EBX power cable
2. Connect the 3-pin plug of the cable to ATXF1 (ATX feature connector).
3. Connect the power on/off button to JPF1(9-10)
Default value is set ATXF1 to short pin1-2.
Important Make sure that the ATX power supply can take at least a 10mA load on the
5V standby lead (5 VSB). If not, you may have difficulty powering on your system.
Table 2.1: Front Panel LAN indicator connector
LAN Mode LED1 LED2
1000Mbps Link On Green On On
1000Mbps Active Green on Green Flashes
1000Mbps Link Off Off Off
100Mbps Link On Orange On Green On
100Mbps Active Orange On Green Flashes
100Mbps Link Off Off Off
10Mbps Link On Off Green On
10Mbps Active Off Green Flashes
10Mbps Link Off Off Off