User's Guide

27/4140
üü To exit this mode, press “CLR”.
!
The display is “o-A xxxx:yy h:m”, where xxxx is
hours and yy is minutes.
!
The factory default Call Timer access code is 12,
but it may be changed if you desire.
Please refer to the section entitled “User
Programmable Codes.”
!
The number you enter as an access code should
be written down and stored safely!
Cumulative Call Timer
The Cumulative Call Timer keeps a running total of on-line
usage in hours:minutes format.
This timer resets to 0000:00 after 9999 hours and 59
minutes have been accumulated
üü To display the value of the Cumulative Call Timer,
press “FNC”, “*”, “3”, “2”, and enter the registered 2
digit Call Timer access code.
üü To manually reset the call timer to 0000:00, press “*”,
“CLR”.
üü To exit this mode, press “CLR”.
!
The display is “C-A xxxx:yy h:m”, where xxxx is
hours and yy is minutes.
!
The factory default Call Timer access code is 12,
but it may be changed if you desire.
Please refer to the section entitled “User
Programmable Codes”.
!
The number you enter as an “Access Code”
should be written down and stored safely!
Temporary Accumulated Call Counter
This feature is used to check the temporarily accumulated
(reset to 0 on the 10,000th call) number of calls.
üü To check the number of calls made, press “FNC”, “*”,