User's Guide

13/4140
stop and the IN USE indicator will appear in the display
panel.
üü To answer an incoming call when the handset is
removed from its cradle, press any key except the ,
or “END”. IN USE will light and you may proceed
with the call as usual.
üü To hang up the phone after or during a conversation,
press “END”, or simply replace the handset in its
cradle.
!
If calls go unanswered, the words “calls missed”
and the number of unanswered calls will appear
and remain in the display until a call is
originated.
Silent Incoming Calls
If the Silent Alert feature is set, a single beep and a flashing
“CALL” message on the display will alert you of an
incoming call.
Once you have switched to silent alert, the phone stays in
that mode until you deactivate it.
üü To activate this mode, press “FNC”, “8”.
“Silent Alert On” should light in the display, indicating
that the Silent Alert Feature has been set.
üü To deactivate this mode, press “FNC”, “8” again.
“Silent Alrt Off” should light in the display, indicating
that the Silent Alert Feature has been turned off.
u Reviewing the Preceding Digits
A condition may arise while entering numbers longer than
15 digits, when the leftmost part of the entered number scrolls
off the display and out of view. The entered number under this
condition exists within three possible segments of digits.
üü To view digit segments which have scrolled off the
display panel, press “FNC”, “*”, “8”.
The digits/digit segments displayed depends on the