Installation & Assembly

SAFETY NOTE: Concealed In-Wall support backing is ALWAYS REQUIRED for this product (not
included) – and must be supplied and selected by a licensed installer/contractor to meet both
weight bearing and local code requirements.
PRODUCT INSTALLATION SHOULD BE DONE BY A LICENSED INSTALLER/CONTRACTOR.
CAUTION: Personal injury and/or property damage may result from improper wall support or
mounting, which is not covered under warranty.
Installation Notes:
1. Bar as Selected
2. Flange Cover Plate
3. Flange
4. Wood Stud
5. Drywall
6. Tile (if applicable)
7. 1/4” (6mm) Diameter Hole – TILE ONLY
8. 1/8” (3mm) Diameter Pilot Hole into Wood Stud
9. 10/24” x 2” Threaded Stainless Steel Hanger Bolt
10. Threaded Stainless Steel Bolt Nut
Installation Steps
:
1. Read ALL safety warnings before installing the grab bar.
2. Locate wall st ud or previously installed backer board.
3. Use the flange plates to mark the mounting hole locations. (We recommend using a level to achieve
perfect horizontal or vertical mounting.)
4. Drill 1/8” (3mm) di ameter pilot hole inot wood stud.
a. If wall is tiled, drill through the tile with a 1/4” (6mm) diameter masonry drill bit.
5. Drive hanger bolt directly into wood stud using hanger bolt driver leaving 1/4” of thread expos e d.
6. Place Flange over exposed hanger bolt.
7. Screw bolt nut onto hanger bolt.
8. After flange is secured, app ly bead of clear sealant around bottom rim of flange cover plate and
carefully align the cover plate locking tabs with the slots in the flange.
9. Turn the flange cover plate 15 degrees cl ockwise to secure.
IMPORTANT INSTRUCTIONS