Dimensions Guide

SAFETY NOTE: Concealed In-Wall support backing is ALWAYS REQUIRED for this product (not
included) – and must be supplied and selected by a licensed installer/contractor to meet both
weight bearing and local code requirements.
PRODUCT INSTALLATION SHOULD BE DONE BY A LICENSED INSTALLER/CONTRACTOR.
CAUTION: Personal injury and/or property damage may result from improper wall support or
mounting, which is not covered under warranty.
Installation Notes:
1. Bar as Selected
2. Flange Cover Plate
3. Flange
4. Stud
5. Drywall
6. Tile (if appl icable)
7. 1/4” (6mm) Diameter Hole – TILE ONLY
8. 1/8” (3mm) Diameter Pilot Hole into Stud
9. 10/24” x 2” Threaded Stainless Steel Hanger Bolt
10. Threaded Stainless Steel Bolt Nut
Installation Steps
:
1. Read ALL safety warnings before installing the grab bar .
2. Locate wall st ud or previously installed backer board.
3. Use the flange plates to mark the mounting hole locations. (We recommend using a level to achieve
perfect horizontal or vertical mounting.)
4. Drill 1/8” (3mm) diameter pilot hole into stud.
a. If wall is tiled, drill through the tile with a 1/4” (6mm) diameter masonry drill bit.
5. Drive hanger bolt directly into stud using hanger bolt driver leaving 1/4” of thread exposed.
6. Place Flange over exposed hanger bolt.
7. Screw bolt nut onto hanger bolt.
8. After flange is secured, app ly bead of clear sealant around bottom rim of flange cover pl ate and
carefully align t he cover plate locking tabs with the slots in the fl ange.
9. Turn the flange cover plate 15 degrees clockwise to secure.
IMPORTANT INSTRUCTIONS