Measurement Guide

SAFETYNOTE:ConcealedIn‐WallsupportbackingisALWAYSREQUIREDforthisproduct(notincluded)
–andmustbesuppliedandselectedbyalicensedinstaller/contractortomeetbothweightbearing
andlocalcoderequirements.
PRODUCTINSTALLATIONSHOULDBEDONEBYALICENSEDINSTALLER/CONTRACTOR.
CAUTION: Personalinjuryand/orpropertydamagemayresultfromimproperwallsupportor
mounting,whichisnotcoveredunderwarranty.
Installation Notes:
1. Bar as Selected
2. Flange Cover Plate
3. Flange
4. Stud
5. Drywall
6. Tile (if applicable)
7. 1/4” (6mm) Diameter Hole – TILE ONLY
8. 1/8” (3mm) Diameter Pilot Hole into Stud
9. 10/24” x 2” Threaded Stainless Steel Hanger Bolt
10. Threaded Stainless Steel Bolt Nut
Installation Steps
:
1. Read ALL safety warnings before installing the grab bar.
2. Locate wall stud or previously installed backer board.
3. Use the flange plates to mark the mounting hole locations. (We recommend using a level to achieve perfect
horizontal or vertical mounting.)
4. Drill 1/8” (3mm) diameter pilot hole into stud.
a. If wall is tiled, drill through the tile with a 1/4” ( 6mm) diameter masonry drill bit.
5. Drive hanger bolt directly into wood stud using hanger bolt driver leaving 1/4” of t hread exposed.
6. Place Flange over exposed hanger bolt.
7. Screw bolt nut onto hanger bolt.
8. After flange is secured, apply bead of clear sealant around bottom rim of flange cover plate and carefully
align the cover plate locking tabs with the slots in the flange.
9. Turn the flange cover plate 15 degrees clockwise to secure.
IMPORTANTINSTRUCTIONS