INSTRUCTION MANUAL for installing 39.
Tools and Hardware Recommended: Kreg jig and clamp Drill or screwdriver Screws Hardware Included: Locking Devices Back sockets 2 Slides
Building the Drawer Box Minimum/Maximum Cabinet Depth Drawer box length Min-Max cabinet depth with metal rear attachment 229 mm 9" 250–300 mm 9 7/8–11 3/4" 305 mm 12" 326–376 mm 12 7/8–14 3/4" 381 mm 15" 402–452 mm 15 7/8–17 3/4" 457 mm 18" 478–528 mm 18 7/8–20 3/4" 533 mm 21" 654–604 mm 21 7/8–23 3/4" STEP 1) — Choose Drawer Slide Length Determine the drawer slide length you will need.
STEP 4) Install locking devices, which should align inside the bottom front of the drawer box. Screw them into place. Avoid screwing the devices into the bottom of the draw box to keep the screws from puncturing the drawer. STEP 5) Drill a 1/4" diameter by 3/8" deep hole into the drawer back for the metal locator tabs Installing the Slides STEP 6a) —Face Frame We recommend that you use a jig (such as a Kreg Drawer Slide Jig) to make sure you install the slide square and level.
STEP 6b) — Frameless Frameless: For a frameless cabinet, simply screw the slide into the side of the cabinet, also setting it back 1/8”. Again, using a jig will make it easier to keep the slide level, but measuring and marking will also work. Note: image depicts a face frame cabinet that has been modified to demonstrate frameless installation. STEP 7) Place the drawer on thew rails, paying attention to line up the notches and holes in the back of the drawer.
TM
