User`s guide

ManualsBrandsCSG Security ManualsComputer equipmentNVeDVR

60 VEREX Director V4.73 User's Guide 21-0381E v4.7.3

___________________________________________

Common Commands--All Items

(After right-clicking the item)

------------------------------------------------------------------------

- Resolve (when alarms present): Sets the

event/monitoring window to show only the

present alarms for the selected area or device;

- Resolve and Show all Events for This Item

(when alarms present)

: Sets the event/monitoring

window to show all alarms and events for the

selected area or device;

To return the Event/Monitoring Window to Its Previous

State: Click [Return to Previous Filter] at the

bottom of the window.

- Switch to Control & Status screen for this

Item: This jumps you to the form-based

"Control & Status" screen for the selected item.

___________________________________________

Area Commands (After right-clicking an Area)

Also See: "Common Commands", previous/above.

-------------------------------------------------------------------------

- Off / Stay / On: These selections allow

manually arming or disarming the area (i.e.,

setting the arming level);

Tip: If any input points (sensors) are presently tripped

or bypassed, you will be guided though the steps to

deal with this first (bypass / acknowledge).

- Silence (when an item is in 'alarm'): This shuts off

the sounding of present alarms (i.e., shuts off

the system siren output, and LCD keypad

sonalerts).

- Worklate: This allows adjusting the area's

scheduled closing time in increments of 30

minutes.

- Lock All Doors in this Area: This locks all

doors with at least one reader associated with

the specific area;

- Unlock all Doors in this Area: This unlocks all

doors with at least one reader associated with

the specific area;

- Reset User Count In Area: This allows

resetting this area's "user-count" to zero.

Note: 'User-counting' is configurable for each area.

Ref: Configuration ÖAreas ÖActivity.

___________________________________________

Door Commands (After right-clicking a Door)

Also See: "Common Commands", previous/above.

-------------------------------------------------------------------------

- Lock: This locks (re-locks) the specific door.

- Unlock: This unlocks the specific door.

- Momentary Normal Unlock: This unlocks the

door for a duration equal to the standard "unlock

duration". This is the same as someone gaining

entry with an access card or token.

- Momentary Extended Unlock: This unlocks

the door for a duration equal to the "extended

unlock duration". This is the same as a user

who is set for "extended unlock/challenged"

gaining entry with an access card or token.

- Pending Unlock: This is an unlock command

that waits for one person to enter the facility at

the specific door.

- Grant Last User -- Reader 1 (or 2): If the last

user at a reader was denied access, this will

issue a 'Momentary Unlocking', and log that

card/user as being granted entry.

• Cards can be denied due to being expired, locked

out, wrong time, wrong door class, etc. -- as long as

they are defined in the system.

• This feature will be unavailable if someone else is

granted entry, or after 5 minutes from the time the

person was denied access (although they can

simply present their card/token again).

• This may be used in conjunction with an event-

triggered camera-view for the door (so a remote

attendant can see the person).