User`s guide

358 VEREX Director V4.73 User's Guide 21-0381E v4.7.3
The follow ing table shows keypad tones for the indicated conditions. Tones that are different f or
“Standard” vs. “Reversed” are shown in bold.
Tip
: “Standard” versus “reversed” tones is selectable under:
Account Information, ÖSetup, Ö”Arm/Disarm and Tones”.
LCD keypad Tones
Condition Standard Tones Reverse Tones
Fire 1 second on and off. 1 second on and off.
Chime Three 125 ms, short low level
beeps
Three 125 ms, short low level
beeps
Exit/Entry Delay Slow turn on/off tones:
On Time: 250 ms
Off Time:750 ms
Steady continuous tone
Exit Delay with point open
(see note below)
Fast turn on/off tones
On Time: 250 ms
Off Time: 250 ms
Fast turn on/off tones
On Time: 250 ms
Off Time: 250 ms
Confirm Exit delay Fast turn on/off tones
On Time: 250 ms
Off Time: 250 ms
Fast turn on/off tones
On Time: 250 ms
Off Time: 250 ms
Trouble – Alarm,
Area Fail to Arm
(see note below)
Steady continuous tone Slow turn on/off tones:
On Time: 250 ms
Off Time:750 ms
Entry delay with
was/current in alarm
Very Fast turn on/off tones
On Time: 125 ms
Off Time: 125 ms
Very Fast turn on/off tones
On Time: 125 ms
Off Time: 125 ms
Area closing – 15 minutes Three 125 ms, short tones.
Tones faster during last 5 minutes
Three 125 ms, short tones.
Tones faster during last 5 minutes
Note: For conditions referencing this note, the tone will NOT be generated if the applicable area’s “Fail to Exit Mode” is
set to None/0 (zero).
Keypad Tone Reference (≥V4.5 with ≥V4.42 firmware)