User`s guide

21-0381E v4.7.3
Welcome Report Control Admin
Sys Config Tech-Ref
225
hour rating for the main panel's backup
battery (such as 7.0). This must be
set by (or confirmed with) an on-site
technician;
- Enable wall tamper
(xL Panels): This
sets whether or not the tamper switch
on the back of the panel main board
will be monitored.
LCD Keypad Only
- System Message: A greeting of up to
16 characters to appear at LCD
displays (alternates with the time, and
alarm conditions).
Also See: Configuration, ÖModules,
Keypad , "Default Display Mode"
 Expansion Modules
I/O Mapping  (≥V4.4)
- Panel on-board Inputs: The number
of input points (zones/sensors)
supported by the main panel itself.
- Panel on-board Outputs: The
number of programmable outputs
(electronically-switched devices)
supported by the main panel itself—plus any
VBUS and STU outputs.
- Paging Output base: The number of the first
programmable output to be reserved for use
with the numeric paging feature supported by
the main panel (i.e., the first one in the reserved
range).
- Paging Outputs: The total number of
programmable output numbers to be reserved
for use with the main panel's numeric paging
feature (up to 16).
Note: Numeric paging is not supported with UK/ACPO
operation.
- VBUS Output base: The number of the first
programmable output to be reserved for use
with the VBUS feature supported by the main
panel (i.e., the first one in the reserved range).
- VBUS Outputs: The total number of
programmable output numbers to be reserved
for use with the VBUS feature supported by the
main panel (up to 32).
VBUS: This pertains to communications between
intelligent power supplies in a master/slave
configuration. To be supported by xL panels.
- Parallel STU Output base: The number of the
first programmable output to be reserved for use
with a parallel STU (i.e., the first one in the
reserved range).
- Parallel STU Outputs: The total number of
programmable output numbers to be reserved
for use with a parallel STU (up to 8).
STU: This pertains to an internal (modular) interface
to a subscriber terminal unit (such as REDCARE)
which is used for reporting purposes. To be supported
by xL panels set for UK/ACPO operation.
Related: Configuration, ÖOutput Points
 Programmable Outputs (Signalling & Device-
Switching)
(!!! Ö)
Configuration, ÖSystem, Ö(Standard )