User`s guide

21-0381E v4.7.3
Welcome Report Control
Admin Sys Config Tech-Ref
151
associated user is granted entry. This
helps to ensure that any faulty sensors
are not forgotten;
- Suspend Schedule: Indefinitely
suspend schedule(s) for the applicable
area(s).
- Emergency Off
(≥V4.4): The ability to
disarm the selected areas after-hours
(i.e., outside of the area's schedule)
including holidays
;
Notes: To enter an area that is armed
during their assigned times, users must
also have the applicable 'Disarm' authority
for the specific area (see Arming, to
follow). "Emergency Off" authority is not
needed for areas set to "Allow out of
schedule opens".
Details
: Configuration, ÖAreas, ÖScheduling.
 Areas and Related Settings
- Isolate (≥V4.4): The ability to isolate input points
(sensors/zones). This is similar to bypassing
an input point, except an 'isolation' remains in
effect until it is removed manually.
(Also see 'Bypass', previous.)
--------------------------------------------------------
 Arming

Note: Any three defined schedules can be assigned
throughout each authority (plus "Always" or "Never").
Per a Schedule
or 'Always': Pertaining to disarming
(to Stay or Off), the area's schedule must also be in
effect unless either "Emergency Off" authority is also
provided (previous), or the area is set to "Allow Out of
Schedule Opens".
Never
: Blocks the applicable arm/disarm ability. Note:
Inability to disarm also blocks the ability to enter an
armed area.
Tip: In the selections, "In Schedule" means during the
selected schedule, and "Out of Schedule" means after-
hours (i.e., outside of the selected schedule).
To define a schedule, refer to "Schedules for User
Access and Area Automation".
- Schedule ON: Determines if and when
associated users will be able to arm applicable
areas (to ON);
On: All sensors monitored (including interior motion
detection).
- Schedule OFF: Determines if and when
associated users will be able to disarm
applicable areas (to OFF);
Off: Only 24-hr and life/safety sensors monitored;
- Schedule STAY: Determines if and when
associated users will be able to arm or disarm
applicable areas (to STAY);
Stay: Perimeter doors / sensors monitored (plus 24
hr / life-safety);
--------------------------------------------------------
 Access

- Area access is permitted: The area arming
levels for which the assigned users will be able
to enter the selected areas. (i.e., when the area
is Off, armed to Stay, and/or fully armed to ON).
- Master Override: This allows a person such as
a security officer to enter at any door that would
normally deny access.
Items Overridden: 'Wrong time' (and door class
settings), 'cards locked-out', APB (if NOT set for strict
enforcement), readers in 'dual-custody' or 'escort'
mode (and allows the person to act as an escort).
Items NOT Overridden
: 'Wrong area or floor',
card/PIN mode, 'strict APB', door 'interlock' issues,
and 'disarm' authorities.
- Escort: Whether or not users assigned to this
authority will be considered as "Escorts" (for use
with "Escort-Required Visitors" (to follow), and
the "Escort" reader mode for doors in the
selected areas).
Related Setting: "Reader Mode" in the door
configuration section.
- Visitor (Escort Required): With this selection,
the person is tracked as they 'badge' throughout
the facility, but access is not granted until a valid
escort's card is also presented.
To Block a Visitor from Using LCD Keypads: Locate
them in the 'Users' screen, and ensure their PIN is
blank.
Type of Cards that can Escort Visitors
: This can be
changed as desired (the present setting is shown on-
Authorities (for users)