User`s guide

21-0381E v4.7.3
Welcome Report
Control Admin S ys Config Tech-Ref
109
Then, refer to the item-d escriptions
for this screen w hile selec ting your
desired command:
• To apply or remove access-control
for all
floors as accessed from all
elevator (lift) cabs, refer to the "Floor
Command for All Floors and All
Elevators" selections.
• To apply or remove access-control
for (i.e., secure or desecure) an
individual floor--as accessed from all
elevator (lift) cabs, refer to the "Floor
and Elevator Status" selections.
If commands or button(s) are not available,
this means you do not have the authority to
control elevators.
Elevators and/or specific floors can be set to
desecure and resecure in-sync with a
desired schedule. For details, refer to the configuration
topic for elevators and/or floors.
- Floor Command for All Floors and All
Elevators: This allows applying or removing
access-control for all floors and all elevators at
the same time
(requires appropriate authority).
- Legend: This shows what the various colours
can mean pertaining to floor and elevator status.
No C&S: This means that no status information is
available because you are not connected to the
specific panel (i.e., a different panel within a multi-
panel account).
- Floor and Elevator Status: This area shows a
list of all controlled floors in the system, plus the
status of each floor, and provides selections to
secure or desecure each floor (as accessed
from all elevator / lift cabs in the system).
Elevator (lift) numbers (1 - 32): These columns
indicate the status of the associated floor selection
relay for each individual elevator (lift) cab.
Tip
: If floor relays are off-line, be sure to dispatch
someone to correct the problem.
Control & Status ÖPanel Control & Status ÖFloors