User`s guide

21-0381E v4.7.4
Welcome Report
Control Admin Sys Config Tech-Ref
91
 To apply or remove access-control
for (i.e., secure or desecure) an
individual floor--as accessed from all
elevator (lift) cabs, refer to the "Floor
and Elevator Status" selections.
If commands or button(s) are not available,
this means you do not have the authority to
control elevators.
Elevators and/or specific floors can be set to
desecure and resecure in-sync with a
desired schedule. For details, refer to the
configuration
topic for elevators and/or
floors.
- Floor Command for All Floors and
All Elevators: This allows applying or
removing access-control for all floors
and all elevators at the same time
(requires appropriate authority)
.
- Legend: This shows what the various colours
can mean pertaining to floor and elevator status.
No C&S: This means that no status information is
available because you are not connected to the
specific panel (i.e., a different panel within a multi-
panel account).
- Floor and Elevator Status: This area shows a
list of all controlled floors in the system, plus the
status of each floor, and provides selections to
secure or desecure each floor (as accessed
from all elevator / lift cabs in the system).
Elevator (lift) numbers (1 - 32): These columns
indicate the status of the associated floor selection
relay for each individual elevator (lift) cab.
Tip
: If floor relays are off-line, be sure to dispatch
someone to correct the problem.
Checking Status or
Bypassing Input Points
(Sensors)
Status of Monitored Sensors
(Input Points)
The 'point' status screen shows the status of
monitored sensors, and lets you bypass a
faulty sensor to allow arming an area.
Permissions/Authorities: This feature can be used by
operators with "Control and Status" permission, when
they log into 'Control & Status' as a user with the
authority to bypass input points.
Also See ( V4.0):
+ Visual Status and Control (Maps and Cameras)
+ To connect: "New Installation? Try the Wizard"
Initiate a Connection, and Access
this Topic
See if you're already connected with the
panel(s) by checking the status bar at the
bottom of the monitoring window.
Control & Status Panel Control & Status Floors