Operating instructions

GT 300 A/II 31/08/06 - /ND

Assembly GT 330

Tools required

• Tube of silicon caurk

• Side cutter (for cutting thermocord)

• Wire brush (for cleaning section openings): use of a *1" fitting brush attached to cordless saves time.

• Sand cloth (for cleaning nipples): Using a power brush saves time.

• Solvent

• Wooden or rubber mallet

• Tightness sealant: See step 28

THESE TOOLS ARE IN ADDITION TO YOUR NORMAL TOOL REQUIREMENTS.



some spare screws are provided.



Warning : the order of assembly is given by the numbers of the various figures.

Symbols used



Caution danger

Risk of injury and damage to equipment. Attention must be paid to the warnings on

safety of persons and equipment



Specific information Information must be kept in mind to maintain comfort

Reference Refer to another manual or other pages in this instruction manual