Users Manual

3·Operation:
1. step1.Op
en the remote control battery cover, load two 7 cell, the
three light-emitting diodes are in a flickering state on the panel.
2. step2.Open the baby carrier’s power, the three light-emitting diodes
are changed from flashing to two luminous tube are normally on,
the code success, can be used.
3. step3.The remote controller has memory function after the code
succeeds, Again to use, no code is necessary unless the battery is
replaced,repeat t above 1-3 steps.
4. step4.The remote does not to use for a long time, will go into
hibernation, the light-emitting diodes extinguish, Again to use, press