Installation Guide

3
PAGE
Carriage
removal
notch
Track s top
6. Adjust the door height.
When adjusting door height, the wrench should be
horizontal to the nut.
Use the small end of the wrench supplied to adjust the door
for height and plumb.
To raise door: Rotate wrench from left to right.
To lower door: Rotate wrench from right to left.
To lower
door
To raise
door
Adjusting
wrench
Turn nut to adjust
M6 Carriage
M8 Carriage
5. Hang the door.
Position the carriages in the pocket opening approximately
where the mounting plates on the door will be located when the
door is in the closed position.
Slide the door over the T Guide and into the pocket.
Position the door underneath the carriages.
Raise the door up so that the round head of the wheel hanger
shaft lines up with the keyhole shaped hole in the mounting
plate.
Go to page 4 (overleaf)
Twin (Soft Open & Soft Close)
C
IMPORTANT: DO NOT DRYWALL THE POCKET UNTIL THE
SOFSTOP MECHANISM HAS BEEN INSTALLED AND TESTED.
The twin SofStop mechanism fits together as shown below.
Push front and rear pickup mechanisms in the direction
shown to charge them.
Mounting
plate
Adjusting
wrench
Note: The top of the hanger pin screws into a self-locking
Nyloc type nut in the carriage. For the assembly to remain
in its adjusted position over time the hanger pin must be
screwed into the nylon locking portion of the nut by at least
3 full turns. (The thread gets harder to turn once it reaches
the start of the nylon locking ring).
If you raise the door to the maximum height position, the
threaded bolt may contact fixing screw heads. If required,
remove hanger bolt from wheel and remove 2-3mm (1/8”) of
thread.
Activator
To load the SofStop mechanism into the track:
a) Insert the first activator into the notch in the track and
slide it to the end of the pocket. Do not tighten the screws
- this position is temporary.
b) Insert the rear carriage, cassette and front carriage using
the same method as Single Sofstop (B).
Secure the carriage to the cassette.
Slide activator
to end of
pocket
7. Insert the track stops (if required).
Once the door is installed and running smoothly, insert the
track stops into the track (if not already fitted) and tighten in
the correct location.
5. Depress the plunger using the wheel hanger shaft head
and slide sideways using the adjusting wrench until it
snaps into locked position. Repeat for the other carriage.
SofStop
cassette
Front
carriage
Rear
carriage
M5 pan head
machine screw
Front pickup
mechanism
(in charged
position)
Rear pickup
mechanism
(push this way
to charge)
Dolly
wheel
Rear
carriage
Front
carriage