Installation Guide

2
PAGE
4. Fit the carriages.
If the pocket frame has been supplied with head
jambs fitted, remove the jamb from one side to allow
access to carriages for mounting and vertical height
adjustment.
Screw fix pocket
header into lintel/
stud when using
heavy doors
Clearance 3/8”-
13/16” (adjustable)
1 3/8”
Lintel
Head
top
approx. 3/8” clearance
Timber
pelmet block
Head jamb
(supplied unfixed)
Head jamb
A. Standard M6/M8 (non-SofStop)
SofStop cassette
b) Insert the cassette into the notched end of the track, dolly
wheel first, ensuring that the pickup mechanism is facing
up.
c) Slide the front carriage into the track with the tow bar
facing into the pocket.
2
1
SofStop
cassette
Front
carriage
d) Secure the carriage to the cassette with the M5 pan head
machine screw.
Tighten with a #2 Phillips drive.
M5 pan head
machine screw
To load the SofStop mechanism into the track:
a) Insert the rear carriage in from the notched end of the track.
Single (Soft Close)B
Insert the carriages into the track through the notched end,
taking care not to damage the wheels on the sharp edge of
the track.
Fit the carriages (A, B or C).
Single (Soft Close)B
Front
carriage
Dolly
wheel
M5 pan head
machine screw
Rear
carriage
SofStop
cassette
Pickup
mechanism
(push this way
to charge)
The single SofStop mechanism fits together as shown
below. Push pickup mechanism in the direction shown to
charge it.
Fix after door
installation
Rear carriage
Rear carriage