Instructions / Assembly

MODEL#: SOL-9328-EB
ASSEMBLY INSTRUCTIONS
WARNING:
Electrical Danger
Turn Power Off
All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
U
L
R
C
2017-09-20
You will need 6 – Cand.Bulb
40 Watts Recommended
60 Watts Max
USE LED BULBS FOR EXTENDED USE
California T24 JA8-2016 Qualified: Satco
(S9618); 5 watt LED Candelabra Base
recommended. Bulb not included
95 Cantiague Rock Road , Westbury, NY 11590 • toll free: 1.800.888.4470 fax: [phone] • [e-mail] • www.crystorama.com
Assembly:
1.To install glasses, place the candle sleeves (3) onto the sockets. Install the bulb(2). Then place the glass shade(1) over the bulb(2) and screw
it onto the threaded bobeche(5).
2.Hang the crystal drape (A) at the bottom.
3. The canopy of the fixture can now be mounted to the ceiling by following instruction Drawing 2.
Replacement Glass installation:
1 . Unscrew the glass shade(1) from the threaded bobeche(5) with thread.
2. Replace the new glass shade by screw threaded bobeche(5) with thread.
Bulb replacement:
1. Unscrew the glass shade(1) from the threadaed bobeche(5) with thread.
2. To replace the bulb.
3. Then put the glass shade(1) onto the bulb, screw by the glass ring with thread.
After securing fixture to the ceiling it is
recommended that the gap between the ceiling and the canopy be sealed on
the top and both sides, with a good quality
waterproof caulk or silicone sealant (NOT INCLUDED)