Installation Sheet

All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
WARNING: This product can expose you to Lead,
which is known to the State of California to cause cancer
and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov
ASSEMBLY INSTRUCTION
You will need 3-Cand.BULB
60 watts Max Bulb not included
USE LED BULBS FOR EXTENDED USE
®
MODEL #BEL-A8069-GE
22.2″
12″x12″
Sketch Map
2
2
1
1
Glass
Screw
Nut
3
Glass
How to Install
Front view
L-shaped
metal strap
How to change glass
1.Take the bottom cage down by removing
the cap nuts.
2.Remove the L-shaped metal strap by
unscrewing the screws.
4.Put the new glass panel on and secure it
with the L-shaped metal strap and screws.
1.Place the fixture over the post and mark 3
points on the post at the center of holes on the
post fitter.
2.Drill the holes at the marked points.
3.Make wiring connections, then place fixture base
over the post and secure down by tightening with
side screws
3.If necessary, smooth out the silicone glue along
the glass channel, prior to placing in the new
glass panel.