User manual

AUTOSAT 2 CONTROL U S E R M A N U A L PAGE 5
1 Please read this first
Before commencing the installation, check the consignment for
completeness.
The following items are contained in the shipment:
1 Control unit box
1 External unit and satellite aerial (dish or flat aerial)
1 Connecting cable for power supply, 0.5 m length
1 12-way connector housing
4 Hexagonal screws M6 x 22 A2
4 Washers M6, A2
4 Self-locking nuts M6, A2
12 Self-tapping screws 3,9x25
1 Cable gland feed through for the roof
1 Remote control (optional)
1 Analog or digital receiver (optional)
1 User manual
1.1 Important Note:
Before installation and start-up of your AutoSat 2, please read this user manual
carefully.
Always make sure (even when your AutoSat 2 will be retracted by your starter key) that the
system has really retracted when starting your vehicle. In case of interrupted supply voltage,
for instance, the aerial can no longer be automatically retracted.
Very important: The external unit must be mounted on the vehicle roof with the aerial
retracted in a direction opposite to the driving direction, as otherwise one cannot rule out
that the aerial will be blown up by wind during high-speed driving.
When transporting the vehicle on a train, the aerial must be fixed in the retracted position
by additional suitable means (expander belts, etc.), due to railway wagons being turned
around when re-coupling.
Do not clean your AutoSat 2 external unit with a steam cleaner. The rubber seals used
for sealing will be OK for rain and water spray but cannot survive a water jet with a pressure
of several bars. The use of drive-in wash stations is deprecated and is entirely at your own
risk.
A condition for satellite reception is free sight to the satellite, i.e. even trees cannot be
penetrated by a satellite signal !!