User manual

AUTOSAT 2 CONTROL U S E R M A N U A L PAGE 25
8 Fault elimination
Fault Remedy
No Satellite
found
1) Check, that there is a free line of sight to the Satellite.
Trees will block reception!
2) Make sure, that the required Satellite can be received with your size
aerial at your current location.
3) At the fringe of the Satellite footprint, change the Search mode from
“Course” to “Fine” and repeat the search.
4) The Satellite search parameters have changed. Check with us,
whether there are new parameters or order a current Flash card.
5) Check the Aerial cable to the external unit (tight fit of the connectors
– break in the cable).
No picture,
although the
aerial is in a
receiving
orientation
1) Try other programs at the receiver.
2) Maybe the wrong satellite was found -, push the “SAT“button.
3) Check the connection to the TV set. If the connection is by coax
cable check the TV settings (channel). If the connection is by
SCART cable, the TV set must set to AV or channel 0.
Wrong Satellite
found
1) Repeat the Satellite search:
press “SAT“.
Bad picture
quality
1) Execute the “Fine positioning” function.
2) You are in the fringe zone of the Satellite footprint.
3) if 2) does not apply, check the aerial cable to the receiver. (tight fit of
the connectors – break in the cable)
4) LNB has been turned – polarity incorrect.
Motor does not
turn
1) Check that the Aerial is free to move.
2) Check the conductors of the motor cable: all contacts must be
engaged tightly in the holes of the plug housing.
3) There is an obstacle between the Aerial and the roof (e.g. snow)!
Motor over
current
protection has
tripped
1) Check that the Aerial is free to move.
2) There is an obstacle between the Aerial and the roof (e.g. snow)!
System shuts
down
immediately
1) Check the battery voltage.
2) Your vehicle was started.
Inexplicable
error condition
1) Switch your AutoSat 2 Control off and then on again