User manual

Page 24 U S E R M A N U A L AUTOSAT 2 CONTROL
7.1.2 Connection external motor unit
Prior to plugging in the connector to the external motor unit, check it again for correct seating
of the contacts. If all contacts are fully inserted and in the correct positions (see page 21) the
connector may be plugged in.
7.1.3 Connection power supply
Prior to connecting the control unit with the vehicle power supply, check the supply connector
again, to avoid possible damage due to incorrect connections.
7.1.4 Connecting an external control panel
There are two versions of the control panel. The mounted control panel is provided for
mounting on furniture. With the assembly control panel a 15mm diameter hole for the cable
feed-through must be drilled in a suitable location on the panel housing.
The external control panel is connected directly to the control box by an 8 pin patch cable.
The external control panel has a 2m long mains lead. An overall length of up to a maximum
of 10m is possible. Only use continuous fully shielded patch cables without extensions for
this purpose.
The external control panel is connected to the western jack labelled "control panel” on the
underside of the control box. Make sure that the connector locks into the jack properly.
7.1.5 Initial operation
If all the steps described have been carried out, the system may be operated. If you are not
yet familiar with the details of operation, please read the Operating Instructions (page 9 – 16)
first.