User manual

AUTOSAT 2 CONTROL U S E R M A N U A L PAGE 17
5.2.11 Language
The sub menu “Language“ (Fig. 19) (“Sprache” in german)
lets you select the language for all menus. Currently
available languages are: Deutsch, English, Francais, Italiano
and Nederlands.
5.2.12 Factory settings
Upon execution of the menu item "Factory settings"
(Figure 20), all satellite parameters and modifiable settings
will be reset to the original delivery conditions. To carry out
this action, a security question will appear which you must
confirm by pressing the "Enter" button.
Only execute this menu function, if the system exhibits
problems, which you cannot correct any other way.
5.3 Special functions
5.3.1 Direct selection of fine tuning
By pressing and holding (for approximately two seconds) the "Plus” button, you can re-
execute the fine tuning. As a hint, when the button has been held down for long enough, the
red LED begins to flash.
5.3.2 Direct alternation between two satellites
If the "GO“ button is pressed down for longer than five seconds, the satellite mirror goes
directly to the position of the last satellite. As a hint, when the button has been held down for
long enough, the red LED begins to flash. Consequently you can conveniently switch
between two different satellites (e.g. ASTRA and HOTBIRD).
If you inadvertently press this button too quickly, then the current position will be
shielded and the unit will try to find the same satellite again. For more information on
this see also Chapter 3 (Sequence of automatic satellite search).
AUSTRALIAN version:
to take affect of the alternation between two satellites you only have to press
down this button for a short time.
Fig. 19
Man. Azi.
Language
> Factory set.
Fig. 20
AUS