User manual

AUTOSAT 2 CONTROL U S E R M A N U A L PAGE 15
5.2.6 Backlight
The sub menu “Backlight“ (Fig. 11) lets you change the
background lighting of the LC display. You can select “OFF“,
“ON“ or “AUTO” mode. The standard mode is “AUTO”.
In the backlight mode “ON“ the display is illuminated, as
long as the control unit is switched on. In the backlight mode
“OFF“ the backlight is permanently switched off. In “AUTO”
mode the illumination of the display switches off after
approx. 60 sec, but turns on again if any key is pressed.
With the “Plus“ or “Minus“ button you move the menu
selection arrow (>) up or down to one of the modes (Fig. 12).
The selection is confirmed by pressing the “Enter“ button.
This returns you to the Main menu (Fig. 11).
5.2.7 Manual Elevation of the Antenna
In the "Manual Elevation” submenu (Figure 14) the
antenna gradient can be operated manually.
This function is necessary for installation and service work
and has no further bearing on the operation of the system.
The current position of the antenna is shown in the second
row. The vertical antenna is thereby at 0 degrees and the
horizontal antenna is at 90 degrees.
The third row displays the current signal reception strength.
The values are only updated following the release of the
"Plus” or "Minus” buttons. Motor control is carried out with a
soft start function, i.e. the unit moves extremely sensitively
when the button is first pressed and then the motor speed
increases the longer the button is pressed.
Fig. 11
Fig. 12
Fig. 14
Fig. 13
Figure 14
Manual
E
le.
Pos: 39.5
CN: 156
Search mode
Backlight
> Man. Ele.