User manual

Page 12 U S E R M A N U A L AUTOSAT 2 CONTROL
5.2 Menu details
5.2.1 Main menu
To reach the Main menu, the system must be turned on. On
initial turn on, Fig. 1 will show in the display. The name of the
selected satellite will be shown in the middle line. Now you
have 5 seconds to press the “Menu“ button. If no button is
pressed within this time, the system automatically returns to
stand by mode or starts a satellite search, depending on
whether the system has reception or not.
If the “Menu“ button was pressed, Fig. 2 will show in the
display.
The following functions and sub menus are contained in the
Main menu:
“Fine positioning“
“Satellite“
“Parameter“
“Search mode“
“Backlight“
“Manual Elevation “
“Manual Azimuth“
“Language“
“Factory setting“
5.2.2 Fine positioning
On selection of the function “Fine positioning“ the control
unit optimises the alignment of the antenna to the satellite.
As a rule, no “fine positioning” is necessary after a satellite
search, since this function is carried out automatically at the
end of the search. This function may be useful after manual
positioning.
Fig. 2
Fig. 3
Fig. 1