Operating instructions

PAGE 4 OPERATING INSTRUCTIONS AUTOSAT 2
I. Assembly Instructions
!!! Note
Please read these assembly instructions before commencing installation!
1.0 Scope of Supply
1 Receiver with integrated motor control and IR remote control
1 External unit and satellite aerial (dish or flat aerial)
1 Connecting cable for power supply, 1 m length
1 12-way connector housing
1 Assembly material for satellite aerial
self-tapping screws 3.9x25
1 Junction box
1 Support block for dish aerial or
sealing cap (Waterlock) for plug of flat aerial
2.0 Selection of Installation Site
2.1 Receiver
Initially select site for positioning your receiver. It should be close to your TV
set, if possible and be seen from where you sit, due to the receiver being
controlled by an IR remote control.
!!! Note
When using a separate control with an integral IR receiver supplied as an
option, the receiver may also be concealed in a cabinet.
Please pay particular attention to:
Sufficient ventilation for the receiver, no additional heat sources inside a
cabinet.
The need to reach the receiver conveniently with the necessary cables.
Supply of short screws (max. 7 mm depth into the unit), should the
receiver have to be fastened directly to the housing and in original
bores only.