Operating instructions

AUTOSAT 2 OPERATING INSTRUCTIONS PAGE 23
A.3 Faults and Remedies
Fault Remedies
No satellite found
1) Check whether sight is free in southerly direction.
There will be no reception under trees!
2) There is no transmission on your selected station, try
another station for search.
3) Whilst moving about in marginal European areas: for
searching switch to a station, which can be positively
found.
4) Check aerial cable to external unit (firm attachment of
connector, cable break)
Aerial in position
but no image
1) Check connection to TV set.
2) Should your TV set be connected via an HF cable,
check setting on TV set (channel position).
3) For connection by SCART cable, switch TV set to AV
(or channel 0).
Incorrect satellite
found
1) Repeat satellite search:
MENU key -> SEARCH SATELLITE
Inferior image
quality
1) Perform FINE TUNING from main menu.
2) Your are in the marginal area of the satellite’s
coverage
3) Should 2) not apply, check aerial cable (for firm
attachment of connector)
Motor cannot turn
1) Check whether external unit is free to move.
2) Check connectors of motor cable for firm attachment.
All contacts must be firmly attached to recesses in
connector housing.
Motor overload
protection
1) Check whether external unit is free to move.
Unit switched off
immediately
1) Check battery voltage
2) Your vehicle has been started
Inexplicable
malfunctions
1) Switch AutoSat2 off and on again.
2) Temperature too high, let AutoSat2 cool down
(perhaps there is not enough ventilation / another heat
source nearby)