Operating instructions

AUTOSAT 2 OPERATING INSTRUCTIONS PAGE 19
7.2 STANDBY Key
Switch AutoSat2 to Standby mode by pressing the STANDBY key.
The aerial will remain in receive position and the receiver will switch off (display:
OFF). There is no power consumption in this condition. However, the
AutoSat2 may not be switched on by remote control but only at front of unit. To
remind you that the aerial is extended, an LED will flash on the front of the unit
and the separate controller (optional). Power consumption of this LED is
negligible (0.1 W).
There is also a facility for switching the AutoSat2 to Standby, with the aerial
remaining extended and the TV image disappearing. However, the AutoSat2
may be re-activated by remote control (ON/OFF key) (the unit is under power:
8 Watts !). The time during which the AutoSat2 may be re-activated may be
permanently set once by the STANDBY menu (chapter 6.4) or by pressing the
STANDBY key several times. After expiry of the set time, AutoSat2 will
automatically switch off its power supply. Press ON/OFF key at front of unit or
on separate controller (optional) to enable AutoSat2 again.
7.3 SAT Key: Changing the Satellite
Holding the SAT key will change AutoSat2 from the ASTRA 1 satellite to the
ASTRA 2 satellite and vice versa (ASTRA 2 to ASTRA). This is subject to you
just receiving one of the satellites and the other satellite also being available for
reception at your location.
7.4 AUDIO Key: Selection of Languages
Press the AUDIO key to select language of multi-lingual broadcasts.
Press the AUDIO key to select mono or stereo.
7.5 ON/OFF Key at Front of Unit: Additional Function
Whilst the unit is switched on, additional functions such as Fine Tuning and/or
Search Satellite (same function as in menu) may be activated. (Press ON/OFF
key until insert appears on screen). This additional function is provided in case
the remote control should be relocated or fail.
7.6 #-Key: Adjusting the HF-Modulator
Press and hold the #-key allows adjustment of the modulator channel, should
your TV unit have been connected to the AutoSat2 by a coaxial cable (we
recommend connection by a Scart cable, as this will clearly improve your image
quality). Set channel from 21 to 69 by using the or key. The presently set
channel (channel 38 ex works) will be shown at the front of the AutoSat2. The
and key alters the sound carrier from UK to German mode and vice versa.
Use STORE key for permanent saving.