Operating instructions

PAGE 14 OPERATING INSTRUCTIONS AUTOSAT 2
!!! Note:
Should the same search cycle be activated for the satellite found (ASTRA found
-> Search ASTRA) AutoSat2 will no longer find this satellite during this search
cycle, due to the first found position having been blocked by the new search
cycle -> Switch AutoSat2 off and on again.
6.3 FINE TUNING
Key sequence: MENU Display of main menu, arrow on FINE TUNING
OK Activate fine tuning
Re-optimisation of receiving position. This may be required should reception be
affected by external influences.
In addition, some channels have mildly varying beam directions, possibly
causing an improvement in reception with an additional fine tuning after
changing a channel.
6.4 STANDBY MODE
Key sequence: MENU Display main menu
Arrow on STANDBY
, Set time: OFF 1 … 30 hrs.
STORE Save
The period of time may be set here, within which the AutoSat2 may be re-
activated by the ON/OFF key of the remote control after activating Standby
Mode (STANDBY key, see chapter 7.2).
After expiry of this time, press ON/OFF key on front of unit (centre key) or on
separate controller (optional) for enabling AutoSat2 as power to the unit is cut
off.
!!! Note:
It is recommended to use this function only briefly or when the vehicle is
connected to external mains (220 V) and/or powered by solar power, as in
Standby Mode power input to the receiver is reduced by approx. 50% but the
unit is still consuming approx. 8 W.