Operating instructions

AUTOSAT 2 OPERATING INSTRUCTIONS PAGE 11
II. Operating Instructions
5.0 General
AutoSat2 DVB offers digital channels of factory preset or personally
programmed satellites of the satellites ASTRA 1, HOTBIRD and ASTRA 2.
5.1 Enabling
Please enable your TV first to enable On Screen Display of your AutoSat.
AutoSat2 On: Use centre key at front of unit or key at separate controller
(optional) only.
AutoSat2 Off: Use centre key at front of unit or key at separate controller
(optional) or ON/OFF key on remote control.
After enabling the unit, an automatic search will be started with your last
selected channel active. No further operation will be necessary for
automatic search except you want to change the channel or satellite.
AutoSat2 will be displayed and the aerial is extended to start extension (green
screen).
During this phase only, the search procedure may be interrupted in order
to change channels or to select satellite (see chapter 5.3 or 6.2):
Possible keys for manipulation are:
, 1 change of channel
0 … 9 Channel direct input
LIST Channel list
MENU Search satellite
followed by the search being automatically continued.
During satellite search, AutoSat2 will not react to remote control (except
the ON/OFF key).
5.2 Procedure for Automatic Satellite Search
The search may comprise up to 2 passes, with the second pass searching at a
higher sensitivity until the satellite has been found.
After rough location of a satellite, fine tuning will start, with the system
searching for optimum reception. This may take more or less time depending on
the quality of reception and/or the selected station.
Fine tuning may be aborted by pressing any key. In case of abortion, no
optimum image may be ensured for all channels.