User guide

28
System
Config
Available modes
H-Sync /
V-Sync
This sets the H-Sync (horizontal position) and
V-Sync (vertical position) values. H-Sync and
V-Sync are used to adjust the output video so
that the active region (viewable part) is mapped
currently (centered or fitting within) the output
display device.
Note: This function is different from the
[Position] function as [Position] moves the
video within the active region of the output
video while [H-Sync / V-Sync] moves the
whole output video.
Therefore, this is a “System Config” function
instead of an “Advanced” function. For any
particular output display device, it needs to be
set up once.
The Pixel Magic function includes a chapter to
guide you to set up H-Sync and V-Sync. Please
refer to section [Pixel Magic] function.
Pre Y/C
Delay
This sets the Pre YC delay. The Pre YC delay
refers to the input source.
Level 1 to Level 8 refer to different Pre Y/C
delay timing.
Post Y/C
Delay
This sets the Post YC delay. The Post YC delay
refers to the output video.
Level 1 to Level 8 refer to different Post Y/C
delay timing.
Screen A R Set the screen Aspect Ratio.
Map Resolution
In this mode, Crystalio looks at the pixel
dimension of the configured display device and
sets the aspect ratio accordingly. E.g. if the
display has a resolution set to 1024x768, the
aspect ratio is deemed to be 4:3.
4:3
This sets screen aspect ratio to 4:3 (1.33:1)
16:9
This sets screen aspect ratio to 16:9 (1.78:1)
2.35:1
This sets screen aspect ratio to 2.35:1 (1.33:1)
Customize
This allows the screen aspect ratio to be set to
a non-standard / customized setting
Note: The aspect ratio adjustment increment is
0.05, except that it will also stop at 4:3 (1.33:1)
and 16:9 (1.78:1).
System
Config
Available modes
SDI Polarity This option sets the SDI input polarity.
SDI1
Set SDI1 input source polarity between positive
or negative, or choose [auto detect] for
automatic detection
SDI2
Set SDI2 input source polarity between positive
or negative, or choose [auto detect] for
automatic detection
SDI3
Set SDI2 input source polarity between positive
or negative, or choose [auto detect] for
automatic detection
Note: Incorrect polarity will make the output video
shaking
Output
Sync
Adjust the output sync polarity.
H-Sync
• Negative
• Positive
V-Sync
• Negative
• Positive
Note: Output Sync only available for
analogue output selected
Port
Arrange
This option sets the port arrangement for the
rear panel.
Upper Port
Set the upper port to one of the following:
• Component1
• RGBS1
• RGB1
Lower Port
Set the lower port to one of the following:
• Component2
• RGBS2
• RGB2
Video2/sync
Component/RGB2
Component/RGB1
Cr/R Y/G Cb/B
Video1/sync
LAN
USB
RS232
S-Video1
230
S-Video2