User guide

ManualsBrandsCrystal ManualsToolsHydraulicPump

Instruction Manual

HydraulicPump

Summary of content (9 pages)

PAGE 1
HydraulicPump Instruction Manual
PAGE 2
Contents Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
Overview  1 Overview INTRODUCTION Thank you for purchasing a Hydraulic Hand Pump from Crystal Engineering. This pump provides you with a portable pressure source for calibration of high pressure gauges, recorders, switches, and transmitters. The built-in variable volume gives you precision at any pressure. There are two pressure ports on the pump.
PAGE 4
Features  2 Features For safe and reliable operation please spend a few minutes reading the following instructions. ! WARNING: To prevent damage to the pump and possible injury, never connect your pump to a pressure source greater than 35 MPa (5000 PSIG, 350 bar). Turn off, or isolate, all pressure-generating equipment from the pressure tap prior to connecting the pump. Note: Since handpumps are small displacement pumps, be sure to minimize the volume to be pressurized.
PAGE 5
Operation  3 Operation PRIMING THE PUMP 1 Put a small amount of fluid in the Reservoir; enough to cover the bleed-off valve hole in the TO ESTABLISH A ZERO PRESSURE REFERENCE 1 Check that the pump at the same elevation as the device being tested bottom of the reservoir. 2 Open the Bleed-off Valve.
PAGE 6
CPF Connection Diagram  4 CPF Connection Diagram CONNECTING TO A CRYSTAL REFERENCE To Transmitter NPT MALE MPF-1/8QTM 1/8" Quick Test NPT Male MPF-1/8MPT 1/8" NPT Male MPF-1/4QTM 1/4" Quick Test NPT Male MPF-1/4MPT * 1/4" NPT Male Additional NPT sizes available in non-CPF MP adapters NPT FEMALE To Transmitter MPF-1/8QTF 1/8" Quick Test NPT Female MPF-1/4QTF 1/4" Quick Test NPT Female MPF-1/4FPT 1/4" NPT Female MPF-1/2QTF 1/2" Quick Test NPT Female Additional NPT sizes available in n
PAGE 7
Support  5 Support TROUBLESHOOTING The Pump Will Not Generate Pressure  Reason The pump has probably lost its prime.  Solution If it will not prime, remove the reservoir and insert a small wire into the inlet check valve hole to make sure the valve moves freely. Squirt oil into the inlet check valve while squeezing and releasing the handle. Then reinstall the reservoir and prime the pump.
PAGE 8
Support  6 CONTACT US Phone . . . . . . . . . . . . . . . . . . . . . . . . . . (805) 595-5477 Toll-Free . . . . . . . . . . . . . . . . . . . . . . . . (800) 444-1850 Fax . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (805) 595-5466 Email . . . . . . . . . . . . . . . . . . . . . . . . . . . service@crystalengineering.net Web . . . . . . . . . . . . . . . . . . . . . . . . . . . . . crystalengineering.net Send your comments to: sales@crystalengineering.