Full Product Manual

Page 7
4. Next on HDD setup check
the status of the hard drive.
If it shows as “Formatted”
than it is ready to be used.
Click “Done” to finish the
setup.
If you are having issue
connecting to the internet
please double check the
cat5e cable and make sure it
is plug to the router or
modem correctly.
Advanced users can also
manual config Network
setting and configure the IP
address.
3. Connecting Cameras
1. Now power up all the
cameras and wait about
30~90 sec to see if all the
cameras gets connected.
(If you have issue with
camera connected please
refer our troubleshoot at
page #18)
2. Once you have test to see
all the cameras are
connected and working,
you can now install the
cameras in locations you
want to view with included
screw.