Specification

1. Camera comes with two major parts; the camera and the power adapter.
2. Please note that the camera cable has two ends: one for the power cable and the
other has the Reset button inside.
3. Please make sure all the connections are tight as possible and it is recommended
that you secure the connection with electrical tape as you see it.
4. Use the included extension power cable(15ft) if necessary.
You may connect up to four 15 ft extension cables(60 ft).
1. General Description
2. Add Camera
NOTE: Please try to protect your power source from moisture and other foreign elements.
TIP: If you are replacing a camera, please delete the camera from the connected camera
table rst, to make room for a new camera.
TIP: * If the system does not find the camera, please press and hold the Reset Button
on the camera for about 10 seconds to reset the camera.
1. First set the camera next to the NVR and power up the camera.
2. Check the status light on camera to confirm that it is in "sync" mode, indicated
by rapid blinking.
3. Click
button on the menu bar.
4. Click the “continue” button to start searching for new cameras.
5. Wait for the NVR to automatically search for cameras for 30 to 40 seconds. your camera
should appear in an empty channel in the table.
6. Click the “continue” button to proceed. Check the live view for the newly-added camera
to confirm that it is connecting properly