User Manual

Connecting to transmitter...

OSD display

Link up with transmitter,

Please check video source

channel1. Set the transmitter and receiver to the same frequency .

TX: SLR camera + 7072

RX: Monitor + 3072

3. The receiver and monitor are connected via an HDMI cable.

2. The transmitter and HD source device are connected and powered

by the HDMI cable.

Application Case

4. Turn on the receiver and monitor power, and the receiver will automatically

connect to the last successfully connected transmitter. The TV OSD

displays the following figure:

5. Wait 25~35 seconds, the receiver ’s network indicator and video indicator are

always on, and the monitor displays the camera’s monitor screen. The OSD

display is shown in the figure below.

OSD display

6. Wait for the successful connection of video, the video light will always be on,

and the monitor will normally display the pictures taken by the camera