User Manual

05
06
Used to indicate the network working status of the product.
Used to indicate the video transmission working status of the product.
3. Digital LED:
Used to display the current working channel of the receiver.
8. Battery interface:SONY NP-F970 and compatible battery series.
10. LINE OUT:Connect with powered audio equipment to output audio signal
4. CH button:
5. Mode button:
Receiver:3072
Video indicator
Digital LED
CH button Mode button
Mini USB
HDMI Out
Battery interface
Link indicator
Antenna interface
DC IN
Power
ON/OFF
Battery
interface
Battery interface
Receiver 3072 Interface Introduction
1. Link indicator:
2. Video indicator:
9.Power switch:ON / OFF
a: Short press to switch the frequency channel, and the frequency channel
on LED flicker slowly;
b: Press and hold the button for 3 seconds to pair the transmitter to the receiver,
and LINK indicator and VIDEO indicator flicker alternately.
a. Press and hold the button for 3 seconds to switch the transmission mode:
Normal mode: LINK indicator and VIDEO indicator are on red
RTSP mode: LINK indicator and VIDEO indicator are on yellow
6. Mini USB: Firmware upgrading
7. HDMI Out: Connect the receiver with HDMI device
LINE OUT(3.5mm)
11. DC IN:
This port is connected to a power adapter or other DC power sources
(such as battery pack, etc.).(SPEC:5.5mm )