User Manual

03
04
Transmitter 7072 Interface Introduction
1. Link indicator:Used to indicate the network working status of the product.
3. Digital LED:
5. Mode button:
11. DC IN：
Video indicator
Digital LED
CH button Mode button
Mini USB
HDMI In
Battery interface
DC IN
Antenna interface
Structure & Interface
Transmitter:7072
Link indicator
Battery interface
Power
ON/OFF
Battery
interface
Used to indicate the video transmission working status of the product.
2. Video indicator:
Used to display the current working status and working channel of the transmitter.
4. CH button:
a:
channel on LED flicker slowly;
Short press to switch the frequency channel, and the frequency
6. Mini USB:Software Upgrading
8. Battery interface:SONY NP-F970 and compatible battery series
9. Power switch:ON / OFF
This port is connected to a power adapter or other DC power sources
(such as battery pack, etc.).(SPEC: 5.5mm )
Press and hold the button for 3 seconds to pair the transmitter to the receiver,
and LINK indicator and VIDEO indicator flicker alternately.
b:
a:
output mode:decimal point light on-external audio output; decimal point
light off-internal audio output.
Short press to switch between external audio output and internal audio
b:Press and hold the button for 3s to switch the transmission mode:
Normal mode: LINK indicator and VIDEO indicator are on red
RTSP mode: LINK indicator and VIDEO indicator are on yellow
7. HDMI In: Connect the transmitter with HD video device by HDMI cable
10. LINE In: Connect with a powered audio device to input audio signal
LINE IN(3.5mm)