User's Manual

1. Fix the antennas and adjust their angles as shown in the figure below.
(For details, please refer to the transmission distance description.)
TX
H D M I
S D I D C
DC IN
SDI IN
HDMI IN
7V-36V
Product Installation
Transmitter Installation Steps:
2. Connect Tx with the camera via corresponding
power cable and HD video cables as shown in the figure below.
3. Turn on the power switch to start power supplying.
Power Switch: ON turn on
OFF turn off
4.Press “CH” button to select the corresponding working channel of receiver and
then press “OK” button for confirmation. The LED digits display will display one
of the characters from 1 ~ 9, A and b when the video signal of device is normal.
(TX and RX use same default working channel)
5. The transmitter supports manually switching the SDI audio input mode by long
pressing “OK” button. (Notice: This function is only valid for SDI audio input and
won’t affect the HDMI audio input.)The default value of SDI audio input mode is 0
and the decimal point will be set to be non-bright under this mode; long press “OK”
key button for more than 3 seconds, and then the LED digits display will display
SDI audio input mode as 1 while the decimal point will be bright.
Li-battery
12V power adapter
Camera
Audio input mode 0: adopt internal SDI clock signal of TX
Audio input mode 1: adopt SDI clock signal of SDI input signal
Notice: please rotate the golden
mental part of antenna to
fasten the antenna.
Antenna Pattern 1:
90° angle in the same plane
Antenna Pattern 2:
Right side 45° angle
rotation towards backside